Lionelo Thermup Bedienungsanleitung Seite 7

List of parts (fig. A)
1.
Cover
2.
Bottle/container holder
3.
Warmer
4.
Status LED
5.
Defrost/quick heat
6.
Milk heating
Defrosting
1.
Place a bottle or container with food in the warmer (fig. 1).
2.
Pour water into the warmer until you reach food or milk level. In case of a large
amount of food or milk, the maximum amount of water in the warmer is about 1,5
cm below the upper edge of the device (fig. 2).
3.
Choose defrost/quick heat in the display (fig. 3). Wait for the status LED to glow.
NOTE
Due to high diversity of baby food consistency, it is advisable to frequently stir and
inspect the temperature of food defrosted.
Do not serve milk/food shortly after defrosting.
Quick heating
1.
Place a bottle or container with food in the warmer (fig. 1).
2.
Pour 40 ml of water into the warmer (see: table below) (fig. 2).
3.
Select defrost/quick heat in the display (fig. 3). Wait for the status LED to glow.
4.
Do not heat frozen milk or food. Remember to heat milk or food after defrosting.
NOTE
In case of quick heating, use the device together with a cover.
Bottle Initial temp.
Glass 4°C/41°F
20°C/68°F
Plastic 4°C/41°F
20°C/68°F
Milk heating
1.
Place a bottle with milk or water in the warmer (fig. 4).
2.
Pour water into the warmer until you reach milk or water level in the bottle. In case
of a large amount of water or milk, the maximum amount of water in the warmer
7.
8.
9.
10.
11.
12.
Amount of
water
60ml/2oz
3 min
40ml/1.4oz
2,5 min
4 min
3 min
‑ 7 ‑
On/off switch
Value up
Food heating
Disinfect
Change mode
Value down
Amount of milk
120ml/4oz 180ml/6oz
4 min 5 min
3 min 4 min
5,5 min 6 min
3,5 min 4,5 min
240ml/8oz
6 min
4,5 min
7 min
5 min
EN