Getting Started - Levenhuk Wezzer PLUS LP60 Bedienungsanleitung

Levenhuk Wezzer PLUS LP60 Weather Station
EN
The kit includes: base station, 3 sensors, USB cable, user manual, and warranty.
Also required (not included):
2 AAA batteries for each sensor
3 AAA batteries for the base station
Caution! Please remember that mains voltage in most European countries is 220—240V. If you
want to use your device in a country with a different mains voltage standard, remember that use
of a converter is absolutely necessary.

Getting started

Base station
• Connect the power cable to the device and the DC adapter (not included) via a USB plug
and connect to the AC power supply; or
• Open the battery compartment cover (6) and insert 3 batteries according to the correct
polarity. Close the cover.
NOTE! It is recommended to use an adapter for the continuous operation of the base station,
although battery power is also possible.
• Wait until the indoor temperature is displayed on the base station.
Sensor
• Open the battery compartment cover (1). Set the desired channel with the switch.
NOTE! This weather station can be operated with up to 3 remote sensors. Each remote sensor
that is to be connected must be operated on a different channel. If only one remote sensor is
connected, it should be operated on channel 1.
• Insert 2 batteries according to the correct polarity. Close the cover.
• To re-establish the sensor connection manually, press RESET using a pin.
Sensor connection
• Place the base station and the remote sensor within the effective transmission range.
Ensure that the channels are assigned after you set up the power supply for the base
station and all the sensors.
• If the reception is successful, the display will show the temperature and humidity of the
respective outdoor sensor. If the values are not received from a channel, "—" appears
on the display. Check the batteries and try it again. Check if there is any source of
interference.
• When changing batteries, replace the batteries first in the base unit, and then in all the
sensors, to re-establish the connection. If an adapter supplies power to any of the devices,
briefly disconnect the power to that device when replacing the batteries. If you change
the batteries only in one of the devices (for example, in the sensor), the signal may not be
received correctly.
• The effective range may differ depending on the unit's position. Due to interference
(various remote control devices, etc.), the maximum distance between the base unit and
the sensor may be significantly reduced. In such cases, we suggest moving the base unit
and sensor a little. Sometimes it is enough to move one of these units a few inches!
6