Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Levenhuk Wezzer PLUS LP50 Weather Station
EN
The kit includes: base station, 3 sensors, user manual, and warranty.
Also required (not included):
2 AAA batteries for each sensor
3 AAA batteries for the base station
Getting started
Base station
•
Open the battery compartment cover (11) and insert 3 batteries according to the correct polarity. Close the
cover.
•
Wait until the indoor temperature is displayed on the base station.
Sensor
•
Open the battery compartment cover (8). Set the desired channel with the switch.
NOTE! This weather station can be operated with up to 3 remote sensors. Each remote sensor that is
to be connected must be operated on a different channel. If only one remote sensor is connected, it
should be operated on channel 1.
•
Insert 2 batteries according to the correct polarity. Close the cover.
•
To re-establish the sensor connection manually, press RESET using a pin.
Sensor connection
•
Place the base station and the remote sensor within the effective transmission range. Ensure that the channels
are assigned after you set up the power supply for the base station and all the sensors.
•
If the reception is successful, the display will show the temperature and humidity of the respective outdoor
sensor. If the values are not received from a channel, "—" appears on the display. Check the batteries and try it
again. Check if there is any source of interference.
•
When changing batteries, replace the batteries first in the base unit, and then in all the sensors, to re-establish
the connection. If an adapter supplies power to any of the devices, briefly disconnect the power to that device
when replacing the batteries. If you change the batteries only in one of the devices (for example, in the
sensor), the signal may not be received correctly.
•
The effective range may differ depending on the unit's position. Due to interference (various remote control
devices, etc.), the maximum distance between the base unit and the sensor may be significantly reduced. In
such cases, we suggest moving the base unit and sensor a little. Sometimes it is enough to move one of these
units a few inches!
NOTE! Although the sensor is weather resistant, never place it in direct sunlight or in the rain
or snow.
Time setting
Press the SET button and hold it for 3 seconds. The digits that are to be set are flashing. Press UP or DOWN to
change the value, and then press SET to continue.
The setting order: Hours > Minutes > Year > Date/Month or Month/Date format > Month > Date > Atmospheric
pressure (hPa/mmHg/mb).
4
Werbung
Inhaltsverzeichnis
