Extraordinary Maintenance; Accessories Not Included; Vice; Disassembling Using Vice - SW-Stahl 10278L Bedienungsanleitung

the sliding columns form dust, earth etc. with a little bit of
lithium-base grease.
NEVER LUBRICATE the sliding parts (columns) with
GREASES, OILS, DETERGENS or SVITOL.
14.

EXTRAORDINARY MAINTENANCE

Extraordinary maintenance operations are to be carried
out by qualifi ed personnel; it is advisable to refer to
authorized dealers for repairing operations and original
spare parts.
15.

ACCESSORIES NOT INCLUDED

15.1 Vice

15.2 Disassembling using - Vice
Always refer to the car manifacturer's service instructions Always refer to the car manifacturer's service instructions
or proprietary manual to estabilish the current procedures
and data. This product information sets details of the
applications and the use of the tools only with the purpose
of a generic guide.
It is advisable to unlock the nuts of shock absorbers' cap
before using the machine 10278L in order to easy working
operations. Some automotive manufacturers prescribes
to unlock the clamp nuts of the caps before dismounting
the shock absorbers from the car.
Block the strut of the shock absorber inside the vice in
order to center it on the machine (see fi g. 5).
Put the small arms near the spring and insert the upper
vices in the fi rst coil available.
After having found the right position of the spring on the
vice and after having adjusted the upper vices, block the
5
adjustable arms (fi g.4) locking the screws behind the case
with the key supplied.
Compress the spring using the foot control lever only to
release the pressure that the spring it-self exert on the
cap.
Remove the blocking cup form the shock absorber
unscrewing the nut. Discharge the compression of the
spring and replace the old shaft with the new one.
15.3

Assembling using vice

For assembling make the contrary operations of the
disassembling. Put the new spring in the same position
where the old one was. Press the foot control lever in order
to make the spring stuck to the blocking cap.
Block the cap to the shaft of the shock absorber screwing
the proper nut.
Now the shock absorber is mounted, use the foot control
lever to release completely the spring, then move the
arms on the outside and remove the shock absorber now
reassembled thanks to the machine 10278L.
16.

LUBRIFICATION OF THE DEVICE

Always use of an air line lubricator with these tools.
We recommend the following Filter-Lubricator-Regulator
Unit.
17.

GUARANTEE

SW-STAHL air tools are guaranteed for 12 months from
the date of purchase against any defect or manufacturing
6
1 0 2 7 8 L
13