Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
8. Commissioning
8.1 Kindermann Aktivbox Set² 50+
Turn on the active box via the power button
By pressing the volume control
8.2 Kindermann Aktivbox Set² 50+ BT
Turn on the active box via the power button
By pressing the volume control
direct selection button on the remote control (BAL
8.2.1 Remote control (Kindermann Aktivbox Set² 50+ BT only)
ON/OFF: The green status LED in the front lights up when the device
16
is switched on. If the device is switched off, all LEDs are off as well.
LED DISPLAY: Status LED in the front lights up or is switch off while
17
the device is in operation. When the speacker is switched on again, this
function returns to the default value: LEDs on.
18
MUTE: The red LED flashes when the device is muted.
19
BT: Bluetooth wireless connection: The blue LED in front lights up
if a Bluetooth connection is already active. If there is no paired device
discovered, the blue LED doesn't light up.
20
UNBAL: Selects the RCA stereo input.
21
BAL: Select the balanced Euroblock input.
22
VOLUME: Increases or decreases the volume.
23
BASS & TREBLE: Increases or decreases bass/treble by 1dB each
(available range from -7 to +7dB).
BT PRIORITY: If BT priority is enabled, a wireless connection will always
24
have priority over all other audio inputs. The Aktivobx Set² 50+ BT will
switch to the Bluetooth input automatically as soon as a wireless connection has been established.
AUTO STANDBY: A long press (2 sec) activates/deactivates the auto-standby function. If the function is activated,
25
the device switches to standby mode after 2.5 min without an applied audio signal or without operating
the remote control. As soon as a signal is applied to the selected input source again, the speaker switches on
again. Auto Standby is enabled by default. Pressing the POWER button also turns the speaker set back on.
RESET: A long press (5 sec) resets the device to its factory default values:
26
BT priority ON, Volume = 30, Basses = 0, Trebles = 0.
FLAT: A long press (5 sec) resets the unit to its factory default equalizer values:
27
Basses = 0, Trebles = 0.
11
and set-up volume
1
, select the desired audio source
11
and set-up volume
1
, you can switch the source sequentially. Alternatively you can use the corresponding
21
, UNBAL
1
2
and equalizer
5
6
(balanced or RCA input).
1
2
and equalizer
20
19
or BT
).
16
19
22
24
25
3
.
3
.
17
18
20
21
23
26
27
22
Werbung
Kapitel
Inhaltsverzeichnis
