Commissioning; Kindermann Aktivbox² Set50 W; Kindermann Aktivbox² Set50+ Wbt; Wireless Connection - Kindermann Aktivbox2 Set50 W Montage- Und Bedienungsanleitung

7. Commissioning

7.1. Kindermann Aktivbox² Set50 W
To start up, turn on the MASTER unit (L) using the switch on the rear panel and set the volume and equalizer
to the desired values.
You can select the desired audio source (balanced or unbalanced input) by pressing the volume control knob.
7.2. Kindermann Aktivbox² Set50+ WBT
To start up, switch on the MASTER unit (L) using the switch on the rear panel and set the volume and equalizer
to the desired values. Press the volume control knob to mute the unit.
You can select the desired audio source (balanced or unbalanced input or wireless connection) by pressing the
corresponding control button on the remote control (BAL, UNBAL or BT).

7.2.1. Wireless connection

Press the BT button to select the wireless connection operating mode. For BT pairing, the Kindermann Aktivbox²
Set50+ WBT model shows up on other devices as Kindermann Aktivbox² Set50 W+ (password: "0000"). As soon as
the pairing to the transmitter device has taken place, the Kindermann Aktivbox² Set50+ WBT model works as a
receiver/playback device of the audio signals coming from the transmitter.
Note: To protect the system from possible electrical overloads, a mains fuse is screwed into a screwable fuse holder
at the rear of the MASTER unit. If this melts, switch off the unit, remove it from the wall bracket, remove the power cord
from the device, unscrew the fuse holder, remove the fuse and replace it with an equivalent one. If the new fuse melts
again immediately afterwards, contact our customer service.

7.2.2. Remote control

1
4
7
9
10
(only Kindermann Aktivbox² Set50+ WBT - Ref. No. 8750000131)
2
3
5
6
8
11
12
17