Mounting; Wall Mounting - Kindermann Aktivbox Set2 50+ Montage- Und Bedienungsanleitung

7. Mounting

The following basic rules must be followed:
• Always place the speakers on a solid ground.
• Mount the box on a suffi ciently load-bearing and vibration-free wall.
• For satisfactory sound reproduction, there must be no obstacles between the loudspeakers and the audience.
Adjust the sound pressure levels to the playback needs. Despite their small dimensions, the Kindermann Aktivbox
•
Set² 50 W (BT) have a much better performance than home speakers.

7.1. Wall mounting

1. Choose suitable mounting material for the installation location
(not included in the scope of delivery).
2. When choosing the installation location, pay attention to a suffi cient
bearing capacity.
3. Use the wall mounting plate as a template to mark the three mounting
points. Create the necessary holes.
4. Attach the safety rope independently of the mounting points of the
wall bracket.
5. Now, mount the bracket according to the adjacent drawing and screw
the bracket to the wall. Before doing so, run the saftey and speaker
cables through the square opening of the bracket.
6. Connect the power cord
attention to the correct polarity of the Euroblock connectors.
LAUTSTÄRKE BASS HÖHEN STEREO
MONO
DRÜCKEN
LAUTSPRECHER
AUSGANG 8 Ω
SPANNUNGS-
WÄHLER
230V
115V
Kindermann GmbH, Mainparkring 3, 97246 Eibelstadt Art.-Nr.: 8750 000 130
www.kindermann.com
7. Roughly align the speaker. Place the fl ange
hear a snapping sound.
8. Attach the fuse cable to the back of the speaker
injury.
9. Align the speaker vertically and horizontally as desired. Tighten the hexagon socket screws of the bracket to fi x the
position.
21
8
, the audio cable(s)
SYMMETRISCHER UNSYMMETRISCHER
EINGANG EINGANG
~115/230V STROM
EINGANG
50/60Hz 50W
AN
AUS
T 1A L
250V
5. Fit the bracket in place, after threading the line and loudspeaker wire through the
square hole in the bracket. Secure the bracket to the wall:
5 6
and the connection cable
6. Connect the power supply cables, signal input and link between the two units to
the connectors on the rear part of the housing. Ensure correct polarity in the
Euroblock terminals.
7. Place the acoustic box in its final position, sliding it vertically downwards so that
the rear side of the rail slots into the bracket rail.
8. Secure the safety wire on the rear part of the acoustic box to ensure that it does
not accidentally fall and cause any material and/or personal damage.
9. Orientate the box to achieve the required position on the vertical and horizontal
axes. Tighten up the Allen screws on the bracket to fasten this position on both
axes.
9
15
of the speaker in the guide of the bracket and slide it down until you
7
to additionally protect it against falling and thus damage or
9
to the passive speaker. Pay
7