Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. Mounting
In the packaging of the Kindermann Aktivbox² Set50 W / Kindermann Aktivbox² Set50+ WBT models you will fi nd
everything necessary for installing the two units.
The following basic rules must be observed:
•
Always place the unit on solid ground.
•
For satisfactory sound reproduction, there must be no obstacles between the loudspeakers and the audience.
Adjust the sound pressure levels to the playback needs. Despite their small dimensions, the Kindermann Aktivbox²
•
Set50 W / Kindermann Aktivbox² Set50+ WBT models have a much better performance than home speakers.
6.1. Procedure for wall mounting
1.
Drill three holes of 6 mm each into the wall according to the holes in the bracket.
2.
Insert three dowels (6 mm) into the drilled holes.
3.
Attach the fuse cable to the back of the holder.
4. Place the bracket in the installation location and route the fuse cable and speaker cable through the square opening
of the bracket beforehand. Attach the wall bracket to the wall..
5.
Connect the power cable, the signal input cable and the connecting cable between the two units to the connectors
on the rear of the housing. Make sure that the polarity of the Euroblock connectors is correct.
LAUTSTÄRKE
BASS
HÖHEN
STEREO
SYMMETRISCHER
UNSYMMETRISCHER
MONO
EINGANG
EINGANG
DRÜCKEN
STROM
~115/230V
EINGANG
LAUTSPRECHER
50/60Hz 50W
AUSGANG 8 Ω
AN
SPANNUNGS-
WÄHLER
230V
AUS
115V
T 1A L
Kindermann GmbH, Mainparkring 3, 97246 Eibelstadt
Art.-Nr.: 8750 000 130
250V
www.kindermann.com
6. Move the speaker to its fi nal position. Place it over the guide on the back into the guide of the bracket and slide it
down.
7.
Attach the safety cable to the back of the speaker to prevent it from falling and causing damage or injury.
8.
Align the speaker vertically and horizontally as desired. Tighten the Allen screws of the bracket to fi x the position.
16
7
Werbung
Kapitel
Inhaltsverzeichnis
