Checking Air Pressure In The Stored Pressure Tank - BestWater Jungbrunnen 66-00 ULTIMATE Gebrauchsanleitung

Maintaining the BestWater System 66-00 ULTIMATE
EN
Then insert the pre-fi lter cartridge
with the 20 µm pre-fi lter into the
right compartment. When screwing
in the pre-fi lter cartridges, make
sure that these are only screwed in
fi nger-tight.
Once all fi lters have been replaced
you can place the front hatch back
onto the BestWater system.
Now you can turn on the fl ow of wa-
ter to the appliance.
The system is now producing puri-
fi ed water. The pre-fi lter cartridges
contain the das disinfectant hydro-
gen peroxide (H
through the appliance after mainte-
nance.
62
O ), which fl ows
2 2
After approx. 40 minutes you must
drain all of the water through the
faucet. Wait long enough that the
water starts to trickle slowly out of
the faucet.
Fill the reservoir again and let the
water drain completely through the
faucet one more time. Your annual
fi lter change for the Jungbrunnen
66-00 ULTIMATE is now complete
and you can operate the unit nor-
mally again.
Checking air pressure in the
stored pressure tank
The internal stored pressure tank of
the Jungbrunnen 66-00 ULTIMATE
is equipped with a natural rubber
membrane that helps push out the
drinking water from the reservoir
during extraction.
In order to check the air pressure
in the stored pressure tank, and to
adjust it if needed, refer to the fol-
lowing images for assistance and
follow these steps: