Charge Indicator Lights; Operating The Vacuum - Shark ICZ300EU-Serie Bedienungsanleitung

CHARGE INDICATOR LIGHTS

Low
Charge
TOP OF BATTERY
Charge Indicator
Light
TEMPERATURE ISSUE: FIRST AND THIRD INDICATOR LIGHTS FLASHING ALTERNATELY
If the first and third indicator lights are flashing alternately, the battery
temperature is not optimal. If this happens when charging, leave the battery
plugged in and charging will resume once temperature reaches optimal level.
NOTE: The battery must be charged before first use. A complete charge takes approximately 3.5 hours.
NOTE: The indicator light will shut o 5 minutes after reaching full charge.

OPERATING THE VACUUM

HARD FLOOR
POWER ON/OFF
SETTING
Press power button To vacuum in hard
to turn on or o the floor mode, press
vacuum. the floor select button
until the hard floor
icon ( ) illuminates.
The brush-rolls will
spin slowly to clean
bare floors and small
area rugs.
50 s h a r kc l e a n . e u
Charging: One light flashes
Mid Nearly
Charge Full
SETTINGS
Suction Speeds
O
Eco
Deep Clean Mode
Boost
CARPET SETTING SUCTION MODES
To vacuum in carpet Press the (
mode, press the floor to toggle between
select button until the Eco, Deep clean mode
carpet icon ( ) and Boost modes. To
illuminates. The save battery power,
brush-rolls will spin select Eco mode. For
faster to pick up debris everyday cleaning
below the surface of power, select Deep
your carpets. Clean Mode. For an
extra burst of power,
select Boost mode.
POD, HANDLE, AND WAND ARE DETACHABLE
Full
Charge
DETACH THE POD
Press SHARK GET ANYWHERE
TECHNOLOGY® button on handle
and lift pod o floor nozzle.
DETACH THE WAND
Press the Wand Release button
until it clicks, then pull up on wand
to detach from the floor nozzle.
) button
OPERATING THE VACUUM
TIP: See next page for all the
di erent ways you can use
your vacuum.
DETACH THE HANDLE
Pull the Handle Release trigger to
detach the handle from the wand.
s h a r kc l e a n . e u 51