Buttons And Indicator Lights - Shark AI ULTRA ROBOT 2-in-1 Gebrauchsanweisung

IMPORTANT: The Shark® AI Ultra 2-in-1 Robot has a pre-installed rechargeable battery. Charge the battery
completely before first use. It may take up to 6 hours to fully charge.
To turn ON the robot, press and hold the DOCK
button for 5-7 seconds. To charge, place the robot on
the dock. The robot will beep when charging begins
and the charging indicator on the dock will turn from
green to blue.
If the robot has no charge or it cannot return to the
base, manually place it on the base. When the robot
is properly aligned on the base with the robot's
BACK against the base, the Charging Symbol
the top right side of the base will illuminate. The
robot will beep when charging begins.
NOTE: When manually placing the robot on the base, make sure the Charging Contacts on the bottom of the robot are
touching the ones on the base.
NOTE: When picking up the robot, be careful not to place fingers between the bumper and the base of the robot.
s h a r kc l e a n . e u
CHARGING
When the cleaning cycle is complete, or if the battery
is running low, the robot will search for the dock.
If the robot doesn't return to dock, its charge may
have run out, or if it is in mopping mode, the dock
may be blocked by carpet.
If the Self-Empty Dust Bin is installed, the robot
will dock with its back to the base so that it can
automatically empty itself.
on

BUTTONS AND INDICATOR LIGHTS

RECHARGE & RESUME
Press and hold the DOCK
button for 15 seconds to turn
Recharge & Resume ON or
OFF.
The Recharge & Resume function is turned OFF by
default. Turn ON Recharge & Resume for complete
coverage if your home's floor plan is bigger than
140m². Your robot will return to the dock, recharge,
and can pick up where it left off.
CLEAN BUTTON
Press to begin a cleaning
session and press again to
pause the cleaning session. To
activate Spot Clean to focus
on a 1.5 metres x 1.5 metres
area, press and hold the
CLEAN button for 5 seconds.
DOCK BUTTON
Press to send the robot back
to the base.
CHARGE INDICATOR LIGHTS
Display the amount of charge
remaining in the battery.
WET MOPPING
INDICATOR
The CLEAN button will
illuminate blue when the fluid
reservoir is properly installed.
The CLEAN button will
illuminate yellow if the tank is
empty and needs refilling.
"!" ERROR INDICATOR
See Troubleshooting section
for full list of error codes.
WI-FI INDICATOR
White light: connected to
Wi-Fi.
Red light: not connected.
Flashing White: setup mode.
No light: not set up yet.
s h a r kc l e a n . e u