Panasonic EP-MA70 Bedienungsanleitung Seite 25

To save your preferences
Automatic programmes
You can save your preferred settings set during the Automatic programmes, and have them reproduced next time you are being
massaged.
You can save the settings for each programme.
Example: When using the "REFRESH" programme
1. You have set Air Massage "SHOULDER" and "LEG/FOOT" to "On", and Stretch "CHEST" to "On".
(Air intensity was set to "Level 1" at this time.)
2. "Heat" massage heads was set to "Off", and Back intensity was set to "Level 3".
3. Volume for "voice guidance function" (see page GB42) was set to "Loud".
4. These settings were saved to User
Contents of the saved settings (1, 2, and 3 above) are restored if User
time.
2
When saving your preferences is completed
• The pressed button will turn off, and the power of the
chair will be turned off automatically in approximately
3 seconds.
• Be careful since preferred contents will not be saved when the
power switch is turned "Off" or the power cord is disconnected
during the massage.
Contents that can be saved
• Air intensity and Back intensity settings
• "Heat" Massage Heads on/off setting
• Air and Stretch on/off settings
(See pages GB22–GB23.)
• Voice guidance volume setting (See page GB42.)
* S ettings at the time the Automatic programme is
completed will be saved.
About the "Heat" massage heads and Voice guidance
volume settings
Only these 2 settings are applied to all the Automatic
programmes.
For example, "Heat" massage heads "Off" and Voice
guidance volume "Loud" of the settings saved to User
for "REFRESH" in the above " Example" are applied, even
if User is pressed during a programme other than
"REFRESH". (The settings for Air and Stretch are not
applied.)
All manuals and user guides at all-guides.com
after the massage completed.
1
After the Automatic programme has
finished, or when the massage is
completed by pressing
programme.
: Y our preferred settings (pages GB22–GB23, GB42 (volume)) are
2
Select and press one button from
while the buttons are flashing (approx. 15
seconds).
• Selected button will light. (Example:
If there is another setting already saved, "Other settings are
already registered." will be announced.*
To overwrite the contents with new settings*
press the same button again.
* T his will also be announced when you try to save to a separate
Automatic programme or same Automatic programme contents
that are the same as those already saved.
I f you do not want to delete the settings already saved
press another User buttons.
is pressed when the "REFRESH" programme is used next
displayed and the User buttons will flash.
to store your settings
Press.
Press.
during the
)
GB24