Error Table - bico Swing-flex Mobiletto M2 Bedienungsanleitung

Error table

If an error occurs that is not listed in this table, please contact your specialist
bed dealer or Bico's after-sales service!
Problem
LED in the handset flashes 5x
LED in the handset does not light up
Receiver does not respond
Despite programming, no function
Torch or keypad lighting does not
light up
Several receivers react simultaneously
Solution
– Change the batteries.
– Check that batteries are poled correctly.
– Change the batteries.
– Check the mains connection of the drive,
if necessary restore it.
– Check whether the transmitter has
undergone the programming procedure.
If this is the case, then the control system
is defective.
– Reduce the distance to the drive system
(receiver).
– Ensure that no other transmitter is opera-
ted simultaneously, e.g. garage door
opener, car key etc.
– Check whether the transmitter has
under gone the programming procedure.
– Check the mains power and if necessary,
restore it.
– Repeat the programming procedure.
– Contact your dealer.
– Battery power too low, replace the
batteries.
– Repeat the programming procedure
for the transmitter.