Herunterladen Inhalt Inhalt Diese Seite drucken

FISCHER FGC 100 Benutzerhandbuch Seite 36

Vorschau ausblenden Andere Handbücher für FGC 100:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 4
7
Use
EN
7.1
Driving nails
1. Check the driving depth setting.
2. Bring the nose piece and the removable stand into contact with the working surface.
3. Press the tool against the working surface as far as it will go and until you hear the fan running.
4. Check that the nose piece is perpendicular to the working surface.
5. Pull the trigger to drive a nail.
6. Lift the tool completely away from the working surface after driving the nail, now the tool is ready
again to drive another nail.
7. Check the position of the nail, if it is driven not deep enough or too deep into the surface adjust
the driving depth with the depth adjustment switch accordingly for best setting results.
8. Always remove the fuel cell and the battery when the work with the tool is finished
or before leaving the tool unattended.
7.2 Unload the fastening tool
7.2.1.
Remove the battery
Press the red release button on the bottom of the battery and pull the battery out of the tool.
7.2.2. Remove the fuel cell
Open the fuel cell compartment (see chapter 4.8) and remove the fuel cell.
Close the compartment cover again.
7.2.3. Unload the magazine
Pull the nail push button back until it engages in lock position. Remove all nail strips.
Release the nail push button to get it back into its initial position.
7.3 Usage of the battery charger
To recharge the battery, plug in the battery charger BC 7.2V. When the battery charger is properly
plugged in, the green LED will light up and the charger is ready to use. To charge the battery, insert
the battery into the battery charger in the right way. When the battery is charging properly, the red
LED will light up. When you plug in a battery and the green LED is lighting up, the battery is already
fully charged, and no further charging is needed.
Once the battery is fully charged the green LED will light up instead of the red one. A fully charge of
an empty battery takes around 1.5 hours. If the red and green LED will flash in alternate sequence,
there is an issue or failure with the battery and the battery must not be used anymore.
36

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

560091553411553586553585553587560038

Inhaltsverzeichnis