Dust Filter - FISCHER FGC 100 Benutzerhandbuch

4.6 Indication of battery-LED status
After inserting the battery into the tool, the LED lights indicate the battery power and the status of
the tool.
Status
All three LEDs lights green
Two LEDs lights green
One LED light green
One LED is flashing green
One LED light red
All three LED lights flash red

4.7 Dust filter

The dust filter at the back of the tool can be removed for cleaning
or to interchange it with a new one when dirty. To release the cover
of the dust filter use a screwdriver or anything similar and push
it into the slot at the bottom of the cover. Rotate the screwdriver
downwards to release the cover and take the dust filter out. Clean
the dust filter with pressurized air. Do not use water or oil to clean
the filter. After the cleaning, put back the dust filter the same way it
has been taken out and put on the cover again by pushing it back
into lock position.
4.8 Fuel cell compartment cover
Open the fuel cell cover by pulling the door
and rotate. The fuel cell cover needs to be
fully opened to be able to insert the fuel
cell. Close the door again after inserting
the fuel cell.
4.9 Belt hook
The belt hook can easily be adjusted to right- and left-hand use.
Unscrew the locking bolt, turn around the belt hook and the locking bolt
and fasten the screw again.
Meaning
The tool is ready, and the level of capacity is between 100% and 60%
The tool is ready, and the level of capacity is between 60% and 30%
The tool is ready, and the level of capacity is between 30% and 10%
The tool is ready, and the level of capacity is between 10% and 5%
The tool is ready, and the level of capacity is below 5% and should be
recharged soon
The tool has some issue and should not be used anymore,
see troubleshooting (chapter 9) to get the tool working again
EN
2
3
1
33