Solutions To Problems - TEXA TTC Bedienungsanleitung

9 SOLUTIONS TO PROBLEMS

For any technical problem non-solvable following the instructions below,
please contact your Distributor/Dealer.
PROBLEM
With the tool connected
to PC, the indication of
battery in charge does
not pop up.
The measurement
clearly wrong.
The tool is switched on
and charged, but does
not measure.
58
PROBABLE CAUSE
The PC is not switched
on or is in stand-by.
The USB cable is not
connected properly or is
defective.
The distance between
microphone and belt is
excessive.
The point of the belt
where the measurement
is done does
correspond to the one
is
indicated
manufacturer.
The environments
where the measurement
is done is too noisy.
The tool is damaged,
possible damages to the
microphone.
The microphone is not
pointed towards the belt.
POSSIBLE SOLUTION
Turn on the PC.
Check connection and/
or replace the cable.
Point the microphone
towards the belt while
keeping
prescribed distance.
Place the microphone in
the point indicated by
not the
manufacturer,
by the keeping
prescribed distance.
Minimize
background noise of the
environment as much as
possible.
Contact the Distributor/
Dealer.
Point the microphone
towards the belt while
keeping
prescribed distance.
it at the
vehicle
while
it at the
the
it at the