Electromagnetic Compatibility - Siemens SIMATIC IFP1500 ETH Produktinformation

SIMATIC
Industrial monitors
SIMATIC IFP1500/1900/2200 ETH
Product Information
A5E41610279
Valid scope
This product information is valid for the following devices:
● SIMATIC IFP1500 MT Ethernet with Siemens logo, article number 6AV7466-5MA00-0AX0
● SIMATIC IFP1500 MT Ethernet, neutral, article number 6AV7466-5MA00-0AA0
● SIMATIC IFP1900 MT Ethernet, neutral, article number 6AV7466-6MA00-0AA0
● SIMATIC IFP2200 MT Ethernet, neutral, article number 6AV7466-8MA03-0AA0
The electronics and interfaces of the devices are based on Industrial Flat Panels IFP1500, IFP1900 and IFP2200 with
capacitive multi-touch screen in the "Extended" version and the Ethernet monitors, and provide the corresponding
functionality. You can find the description of the IFP1500, IFP1900 and IFP2200 in the "SIMATIC HMI Industrial Flat Panels
IFP, IFP PRO, IFP ETH (http://support.automation.siemens.com/WW/view/en/65288650)" operating instructions on which
this product information is based.
This product information describes the technical differences of the devices compared to IFP1500, IFP1900 and IFP2200.
Unless otherwise described in this product information, all specifications in the underlying operating instructions for IFP1500,
IFP1900 and IFP2200, that is specifications regarding hardware, software, maintenance and service, apply to these devices.
However, the statements in this product information take precedence in terms of the binding character over all statements in
the underlying documentation:
● Operating instructions
● Release notes
● Online Help
Safety instructions and additional notes
Safety instructions
The general safety instructions in the "SIMATIC HMI Industrial Flat Panels IFP, IFP PRO, IFP ETH" operating instructions
apply to all devices with a capacitive multi-touch screen and Ethernet monitors.

Electromagnetic compatibility

Pulse-shaped interference
Devices have been tested for high-energy single pulses (surge) in accordance with IEC 61000-4-5.
An external protective circuit is required for operation with 24 V DC. The same requirements for controllers must be met, see
function manual "SIMATIC S7-1500, ET 200MP, ET 200SP, ET 200AL Designing interference-free controllers", section 7
"Lightning protection and overvoltage protection", which is available on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/59193566).
The following lightning protection element was used during the testing of the Industrial Flat Panel:
Dehn BVT AVD 24" (Order No. 918 422)
© Siemens AG 2021. All rights reserved
8
A5E41610279-AE, 10/2021