Werbung
6. On-Off switch
7. Mains plug
8. Handle
9. Handle, lower section
Scope of delivery
• Electric ground hoe
• Operating manual
• Handle
• Handle, lower section
• Handlebar reinforcement
• Bag with small parts
Assembly
► P. 4, item 2
– Fit the lower section of the handle (9) to the slot in
the unit as shown in the diagram.
– Insert the carriage bolts and secure using the tog-
gle nuts (10).
► P. 4, item 3
– Place the handle (8) as shown to the lower sec-
tion of the handle frame (9).
– Insert the carriage bolts and secure using the tog-
gle nuts (11).
Operation
Check to make sure the device is in safe operating
condition:
– Check to make sure there are no visible defects.
– Check to make sure all device components are
correctly mounted.
Preparation
Attaching the extension cable
► P. 4, item 4
– Plug the unit plug (7) into the connector of the
extension cable.
– Feed the extension cable through the strain relief
mechanism (4) as shown.
Turning on the tool
► P. 4, item 5
– Press the switch-on safety lock (5). Simultane-
ously press On-Off-Switch (6) hold it in pressed
position.
– Release the switch lock.
Chopping
DANGER! Risk of injury! Before starting
work check the area and remove all objects
which may be kicked up by the unit.
DANGER! Risk of injury! When working,
never let go of the steering.
DANGER! Risk of injury! If use on a slope
where there is a risk of slipping, the unit
must be secured by a second person with a
bar or a rope. The second person must be
positioned above the unit and at a safe dis-
tance from the chopping tool.
Always work at right angles to the slope,
never work up and down. Be particularly
careful when changing direction.
DANGER! Risk of injury! Remove trapped
objects only with the help of another object.
Before carrying out any maintenance or
cleaning work, the machine must be discon-
nected from the power and secured to pre-
vent accidental switch on.
NOTICE! Risk of damage to the device!
Do not move the unit with a rotating chop-
ping tool over cement or asphalt surfaces
etc.
The rotation direction of the chopping tool pulls the
device away from the user.
– To increase the depth achieved, brake the for-
wards motion of the device.
– When turning and pulling the device towards you,
be particularly careful.
Cleaning and maintenance
DANGER! Risk of injury! Never clean the
chopping tool when the motor is running.
Before carrying out any maintenance or
cleaning work, the machine must be discon-
nected from the power and secured to pre-
vent accidental switch on.
DANGER! Risk of injury! Carry out the
maintenance work described here in per-
son.
Improper maintenance work can damage
the device and lead to injuries.
CAUTION! Risk of injury! During and after
use, the chopping tool and drive system
may become hot!
Wear gloves when carrying out mainte-
nance work.
Cleaning and maintenance overview
Before each use
What?
General function
check.
Check screw connec-
tions for tight fit
Cleaning the device
NOTICE! Risk of damage to the device!
Never clean the unit with water or high-pres-
sure jet.
GB
How?
Visual check.
Use a suitable tool to tighten
the screw connections by
hand.
23
Werbung
Kapitel
Fehlerbehebung
