Lan (Gigabit Ethernet) - Balluff Matrix Vision BVS CA-GX2 001 mvBlueCOUGAR-XD Serie Betriebsanleitung

BVS CA – GX2 - _ _ _ _ _ _ - _ _ _ _ _ _ - 001
The duty cycle is a coefficient < 1, which defines the power of the resistor. It is the ratio of the time period while current
flows compared to the total time. If the current always flows, "P = U * I" will be the determining factor. If the current only
flows a hundredth of time (duty cycle 1%), a resistor with a hundredth of power will be enough.
NOTE
For the connected LEDs and the ground of the external power supply, you have to use the
ground of the camera at pin 2.
ATTENTION
Surge
The series resistor has to handle the power, which depends on the duty cycle and the fre-
quency. Otherwise surge is the result and can damage the used LEDs.
→ Use a suitable series resistor.
3.4.2

LAN (Gigabit Ethernet)

The LAN interfaces meets the Ethernet standard in accordance with IEEE 802.3-2008 (up to 1 Gigabit). This network
connection is used to configure the camera and to send the image data.
NOTE
The LAN signals are galvanically isolated from the camera electronics and camera housing.
The cable must correspond at least to category 5e in accordance with EIA/TIA-568. Trans-
fer in accordance with 1000BASE-T/100BASE-TX/10BASE-T is being supported.
Pin
1 BI_DA+
2 BI_DA-
3 BI_DB+
4 BI_DC+
5 BI_DC-
6 BI_DB-
7 BI_DD+
8 BI_DD-
www.matrix-vision.com
LAN1 / LAN2
RJ45
15