Walker Bay 8 Sicherheits- Und Montageanleitung Seite 2

Walker Bay Owners Safety REV2
Upon Purchasing Your Walker Bay Boat
• READ THE OWNER'S SAFETY MANUAL CAREFULLY. If you resell your boat you will need to transfer this manual and the
• Ensure that your MSO, which is located in the same package as this manual, is completed. Your dealer should fill this out at the time of
• Check that all the components listed in the Assembly Instructions are included in your hull or seat box.
• Register your boat (using your MSO certificate & Hull ID #) with your State/Province if required. Regulations vary by jurisdiction, so
Certification
Walker Bay boats are certified by the US National Marine Manufacturers' Association (NMMA), and meet US Coast Guard, Canadian
Coast Guard and European (CE) safety standards. They are designed for sheltered waters including small lakes, canals, bays and rivers
with wave conditions up to and including 1.5ft (.5m). Note that all three (3) seats must be installed for the boat to meet the safety
standards because they contain foam required for flotation.
Warning
• The safety of your Walker Bay boat and its users is highly dependant on uncontrolable variables such as but not limited to the state of
• Read this owner's manual carefully. It contains the minimum information necessary to operate your Walker Bay boat, some safety
• This owner's manual is not a guide to boating safety or how to navigate, anchor, or dock your boat. Your dealer, national sailing
• This owner's manual is not an operation, maintenance or troubleshooting booklet.
• Always maintain your boat properly and adjust your use to the condition of the boat which may wear with time and use.
• Obtaining and maintaining necessary safety equipment is the responsibility of the boat owner.
• A personal flotation device (PFD) is required for each passenger.
• Do not use your boat if you suspect it has a crack or hole.
• Do not use the boat as a tow craft or toy.
• Do not remove the warning label from the boat.
• Do not use the boat under the influence of drugs or alcohol.
Load Distribution and Passenger Positioning
Load distribution is critical for safety and performance in all small boats. Refer to diagram A (Page 9) for reccomended passenger
distribution in your Walker Bay boat.
Capsize Recovery when Sailing
Capsizing is a risk faced in any small boat when sailing. Refer to diagram B (Page 9) for capsize recovery procedure. The minimum crew
mass for righting a Walker Bay boat is 40 Kg.
Repairing Your Walker Bay Boat
With use, your boat will show wear. Most dents or scratches are not problems. They repair themselves with the heat of the sun. For larger
deeper dents, heat the inside or outside surfaces with a hair dryer. Do not overheat the surface – it should not be too hot to touch. When
the area is warm, apply pressure to aid the polypropylene in reforming to its original shape.
In the event of more serious boat damage such as a hole or crack in the hull or seats, do not use it. Contact our customer service line for
repair information.
Characteristics of Polypropylene
• The polypropylene used has been specially formulated to maximize impact resistance. This results in a softer plastic that can be
• Polypropylene does not adhere well to other materials. Small repairs can be made using Walker Bay's authorized repair kit. For larger
Cleaning Your Walker Bay Boat
Your boat can be cleaned with a boat cleaning agent such as Meguiar's Vinyl & Rubber Cleaner. Avoid using oily or abrasive substances.
Read labels and instructions carefully to avoid products that could damage polypropylene or other plastics. DO NOT use products that
contain phosphates, chlorine, solvents, non-biodegradable or petroleum based products. Citrus-based cleaners are excellent for marine
cleaning purposes, and are safe to use. Household cleaners should be used sparingly and not discharged into waterways. Never mix
cleaners and be sure to work in a well ventilated area.
Storing Your Walker Bay Boat
Your boat is UV stabilized and uses only stainless steel hardware, so it will stand up well to the elements for many years. To maximize the
life of your boat we recommend the following:
• Protect your boat with a storage cover or flip it over to prevent water from gathering inside it.
• If your boat will remain unused for long periods of time, store it indoors.
• If you keep your boat in a windy area, tie it down.
2
12/19/02 3:26 PM Page 2
Manufacturer's Statement of Origin (MSO) to the new owner, so please store them in a safe place.
purchase.
contact your local registration office directly. A list of US registration offices is provided.
the weather, sea or water, and the experience and physical condition of the crew; therefore, one can never ensure or assume full safety
of the vessel or users.
topics, and operation and maintenance suggestions.
federation or yacht club should advise you on local marine schools or competent instructors.
1-888-44WALKER (449-2553) or 604-682-5699 or info@walkerbay.com.
susceptible to scuffing. If polypropylene is subjected to severe impact, whitening in the material may occur, but this does not represent a
weakening of the material.
repairs contact our customer service line. If you are required to attach registration decals, you should use the highest possible
adhesion, or contact us for suggested tips for improving adhesion.
Sail Kits and Accessories
Optional sail kits are available for the Walker Bay 8 and Walker Bay 10, in addition to a range of functional accessories including
boat covers, bimini tops, oars, life jackets, etc. Visit our website at www.walkerbay.com for a complete listing of accessory items
available and a dealer nearest you.