Connecting Lead Wires; Preparing For Session - TensCare Eva Bedienungsanleitung

If battery leakage occurs and comes in
contact with the skin or eyes, wash
thoroughly with lots of water and
immediately seek medical attention.
Warning: Keep batteries out of the
reach of children to prevent them from
swallowing them
swallowed by child, contact doctor
immediately.
Caution NEVER attempt to
recharge an alkaline battery.
Risk of explosion.
Caution Do not mix old, new or
different types of batteries as
this may
leakage or low battery indication.
Disposal: Always dispose of batteries
and device responsibly according to
local government guidelines. Do not
throw batteries onto a fire. Risk of
explosion.
12.2. CONNECTING LEAD
WIRES
Insert the lead wire plug into the base of
the unit.
Attaching the electrode pads to the
lead wire.
Push the pin ends firmly into the pigtail
ends of the electrode pads.
by mistake. If
lead to battery
The lead wires may be damaged by
rough handling, and should be treated
with care.
Lead wire colour coding.
The ends of the lead wires are coloured
red or black. One of the electrode pads
should be positioned over the motor
point.
12.3. PREPARING FOR
SESSION
1) Before use make sure your skin is
clean and dry.
If you are using
programmes, clean the skin carefully
before applying electrode pads,
removing all makeup, oils and
creams. Residue from these can
prevent the electrode pads from
adhering properly. Use an Aloe Vera
based cream after treatment to
soothe any skin irritation.
2) Place the electrode pads on the skin,
see section 9.
3) If you are using your Eva while
moving, you can attach the unit to
your belt using the belt clip or hang it
around your neck using a neck cord
(not included). For safety, use thread
or wool that will snap easily if the unit
snags on something.
4) You can safely lean on the electrode
pads. The sensation might change.
Warning: Ensure the Eva is
switched OFF before applying
the electrode pads on the skin.
28
the FACE