Maintenance; Maintenance Schedule - Husqvarna LC 151 Bedienungsanweisung

4. Open the side discharge cover and install the side
discharge deflector onto the support pins.
5. Let the side discharge cover close against the side
discharge deflector. Make sure that the side
discharge deflector is tightly in position before you
operate the product.
Note:
To increase the performance in side discharge
mode, install the mulch plug.
To empty the grass catcher
CAUTION:
you move it to prevent wear.
Introduction
WARNING:
maintenance, you must read and
understand the safety chapter.
For all servicing and repair work on the product, special
training is necessary. We guarantee the availability of
professional repairs and servicing. If your dealer is not a
service agent, speak to them for information about the
nearest service agent.
1566 - 008 - 24.11.2021
Lift the grass catcher when

Maintenance

Before you do
1. Lift the grass catcher with the frame handle.
2. Use the frame handle and the bag handle when you
empty the grass catcher.
To get a good result
• Always use a sharp blade. A blunt blade gives an
irregular result and the cut surface of the grass
becomes yellow. A sharp blade also uses less
energy than a blunt blade.
• Do not cut more than ⅓ of the length of the grass.
Use the highest cutting height when you start to cut
the grass. Examine the result and lower the cutting
height to an applicable level. If the grass is very long,
operate slowly and cut 2 times if it is necessary.
• Cut in different directions each time to prevent
stripes in the lawn.
• Lift the rear cover and remove the grass catcher.
• If a mulch plug and a mulch blade are attached,
remove them.
• Close the rear cover before you operate the product.
When you operate the product, the cut grass
discharges below the rear cover.
• Keep the cutting cover clean. Buildup from grass and
dirt on the inner side of the cutting cover can
decrease the cutting result. Refer to
inner surface of the cutting cover on page 12 .

Maintenance schedule

CAUTION:
is up and not against the ground when you
tilt the product. Risk of engine damage.
The maintenance intervals are calculated from daily use
of the product. The intervals change if the product is not
used daily.
For maintenance identified with * refer to instructions in
Safety devices on the product on page 5 .
To clean the
Make sure that the air filter
11