Oase biOrb EARTH 125 Gebrauchsanleitung Seite 29

17 Temperature and humidity sensor
 The "OASE Control" app shows the current sensor values. Due to the air circulation, different val-
ues may be measured at a different location.
18 Mist outlet and inlet opening for fresh air
19 Power pack
20 Power cable with country-specific power plug
21 Rubber stopper
 For sealing the housing openings when the rear section containing the electronics is removed.
Operating conditions indicated by the LED (15)
LED status
Green Continuous light
Flashing
Red Continuous light
Flashing
Blue Continuous light
Flashing
Off
Button functions (15)
Usage
Press briefly
Hold for 5 seconds
Hold for 15 seconds
Access to the device
Description
biOrb EARTH is operating and has a network connection.
biOrb EARTH is operating and is looking for a network connection.
biOrb EARTH is starting (boot phase) or being reset.
Malfunction pending; possibly ...
 the cover is not positioned correctly.
 the target temperature or the target humidity have not been
reached.
biOrb EARTH is in delivery condition and is waiting for configuration via
the "OASE Control" app.
Liquid reservoir empty (→ Filling the liquid reservoir).
biOrb EARTH is switched off.
Description
Reset "Liquid reservoir empty" message. (The LED stops flashing in
blue.)
Reset network connection. A signal is audible at the end.
Reset biOrb EARTH and app to factory settings. Three signals are audi-
ble at the end.
EN
BOB0326
29