Set-Up Instructions - Gold Note VALORE 425 PLUS Bedienungsanleitung

| SET-UP INSTRUCTIONS

FIRST OPERATION
1
Please remove carefully the protecting
foam and check if all the listed items are
supplied.
2
Place the turntable on a levelled surface.
3
Install the counterweight on the tonearm,
ensure the tracking weight matches the
requirements of your cartridge.
4
Install the drive belt around the motor
pulley first, then carefully run it around
the platter.
5
Connect the turntable to the Speed
Control unit, then plug it to the AC.
POSITIONING THE TURNTABLE
Your turntable has been designed for Hi-Fi
systems. It must be protected from direct sun
and humidity. Do not place it near heating
sources, electrical and electronic motors,
mobile phones etc. The positioning on a
solid shelf, is crucial to achieve the best
audio performances possible.
SPEED CONTROL ADJUSTMENTS
The turntable is fully controlled by an
electronic power supply.
1
Inner button starts and stops the 33
rpm speed. When this speed is playing,
the red LED light is on.
2
Outer button starts and stops the 45rpm
speed. When this speed is playing, the
red LED light is on.
The turntable also features a fine speed
adjustment "Pitch Control" function to allow
for precise calibration of the speed.
PITCH CONTROL MODE
To adjust the speed, press and hold for
4 seconds both the 33
buttons while the turntable is playing either
speed until the red LED light shuts down.
| PITCH –
Press the 33 / rpm button until the correct
1
3
speed is reached. The LED light flashes
every time the button is pressed.
| PITCH +
Press the 45rpm button until the correct
speed is reached. The LED light flashes
every time the button is pressed.
To switch off of the PITCH CONTROL MODE
press and hold for 4 seconds both the
33 / rpm and the 45rpm buttons until the
1
3
LED light is on and steady again.
4
/
1
3
/ rpm and 45rpm
1
3
EN
DE
IT