Factory Settings; Technical Data - M-E Bell-510 Rx Betriebsanleitung

ENGLISH
BELL-510 RX

FACTORY SETTINGS

To reset the radio doorbell to factory settings, press and hold the learning code
button for 3 seconds until the control LED flashes blue. Release the button and
hold it down again until the control LED stops flashing. After this, the radio door-
bell is back in the delivery state and no more transmitters have been learned.
Then switch the radio doorbell off and on again. The control LED flashes blue and
the radio doorbell is in learning mode. Now all the desired transmitters can be
taught in again. Please refer to the section "Programming transmitters".

TECHNICAL DATA

• Operating voltage: 230V / 50 Hz
• Battery: 3.7V/600mAh lithium-polymer battery
• Power consumption (battery fully charged): <1W
• Power consumption (battery being charged): approx. 2W
GB
• Frequency: 434MHz ; <10mW
• Protection class: IP44
• Temperature range: -20°C to +55°C
The battery is permanently installed; it can only be replaced by a specialist
workshop.
20