m-e BELL-510 RX Betriebsanleitung Seite 18

ENGLISH
BELL-510 RX
FUNCTION SELECTOR SWITCH
Use the function selector switch to choose whether the radio doorbell only plays
the ring tone or only the light panel flashes or both together. Slide the switch to
the desired position.
Ring tone only
Only flashing light panel
Ringtone and light panel
CONTROL LED
The control LED indicates various states.
If the radio doorbell is plugged into a 230V mains socket, the control LED flashes
green to indicate the charging process.
If the LED lights up green continuously while the radio doorbell is plugged into a
GB
mains socket, the battery is fully charged.
If the LED flashes red, the battery is almost empty and the radio doorbell must
be recharged.
If the LED flashes blue, the radio doorbell is in learning mode.
PAIRING THE TRANSMITTER
If no transmitter has been taught-in to the radio doorbell yet, the radio doorbell
is in teach-in mode immediately after it is switched on; the control LED indicates
this by flashing blue. Now trigger the desired Bell transmitter to learn it. The
radio doorbell plays a ring tone and automatically leaves the learning mode.
To teach in another transmitter, press and hold the learning code button for
approx. 3 seconds. The control LED flashes blue when the learning mode is activ-
ated. Then trigger the Bell transmitter to which the radio doorbell is to addition-
18