Troubleshooting - Bestway Flowclear AquaDrift Gebrauchshinweise

HOW TO CLEAN THE PRODUCT
1 2
4
6

TROUBLESHOOTING

Problem
Robot does not capture the
debris, moves slowly or does
not move at all.
The hoses are entangled
The driving path of the robot
cannot cover the entire pool
3
5
7
Possible Cause
Debris compartment is full
Pressure relief valve filter is clogged
Pool suction fitting is clogged
The filter cartridge or sand is too dirty
Air inside the pump
The robot is stuck on wrinkles
Wheel is jammed
The water valve did not open
Damaged debris compartment or
pressure relief valve filter
Hose not straightened out
The hose sinks into the water
The robot running speed is too fast
The wheels are not in the correct position
8
Clean the debris compartment. Rinse with water to remove debris.
Clean the pressure relief valve filter. Rinse with water to remove debris.
Clean the pool suction fitting. Rinse with water to remove debris.
Filter pump
- Stop the pump, block the connector A and B to avoid water flowing out from the pool,
and clean the filter cartridge or replace if necessary.
Sand filter pump
- Disconnect the cleaner from the pool, perform backwash and rinse to clean the sand.
Stop the filter pump or sand filter, purge the air and start again.
Check the bottom of the pool. If there are wrinkles, level the pool to reduce them.
Check to see if the debris screen inside of the head is dirty. Clean the debris screen.
Check to see if the filter cartridge or filter sand is dirty. Clean the filter cartridge or back
wash the filter sand.
Check and remove debris from the wheel.
Open the water valve
Return to the shop to get assistance
Turn off the pump, reconnect the product at the diagonal position of the pool, the water
hose should be in a C shape, the product should be placed into the water in the direction
of the water hose.
Adjust the position of the float to make the hose float on the water.
Regulating pressure relief valve
Adjust the wheel driving angle
4
Solution