Cleaning And Maintenance - SOLIS COMFORT HEATER 688 Bedienungsanleitung

General Switch
Power Indicator
Light
Timing/
Temperature
Display
Power Indicator
OPERATION INSTRUCTION
• Connect the power supply with the product: First connect the power cord into a power outlet with the
correct voltage. Ensure that the device is located on an even and stable surface.
• When standby, only the switch can be used. Press
The acquiescent condition after power on is:

Power: low power working, two heat indicator lights go on.

Timing: 00h (no timing), Led-H is off.

Temperature: Digital control displays the real-time room temperature.

Temperature setting: Automatically set to 25°C.
• When power on, press to circularly switch
Low power  Middle power  High power.

Low power: two heating degree indicator lights go on.

Middle power: four heating degree indicator lights go on.

High power: six heating degree indicator lights go on.
22
Solis_ComfortHeater_Betriebsanleitung.indd 22-23
Control Panel Control Panel
of the Heater of the Remote
to turn on the heater, press it again to turn off.
Tow lights go on Four lights go on
• When power on, press to set timer from 00h to 23h.
• Under the condition of time setting, press again, you can set temperature.
The displaying screen will show the ambient temperature.
• Remote control: the function of remote control is the same with the main machine.

CLEANING AND MAINTENANCE

• Ensure that the device is switched off before cleaning or maintenance – the main switch is in the
position „0" and the power cord is pulled out of the power socket. Before cleaning the device,
allow it to cool down.
• Wipe the surface of the device using a clean and dry wipe. Do not use cleaning products causing
scratching, petrol or other solvents. Do not submerge in water or in any other liquid.
• Never use thinner, toluene, acidic lotion, kerosene, alcohol and chemical rag to clean the machine,
so as not to metamorphose or change color.
• After cleaning, plug in to make sure the machine can work normally, and then pull out the plug and
pacing the device according to the packing order.
• The machine should be put in a place with low humidity and good ventilation.
WARNING:
ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
AVOID CONTACT OF THE HEATER WITH WATER OR WITH ANY OTHER LIQUID.
Six lights go on
23
19.05.10 07:54