Sensica SENSILIGHT mini Bedienungsanleitung Seite 13

Manually change energy
levels by pressing the
energy selection button
to decrease or increase
the energy level according
to your comfort level,
as determined by the
preliminary test. Each press
will change the energy,
from the lower level to
the higher, for a total of 3
different energy levels.
4. The energy level display
indicators will light up green
according to the selected
energy level (e.g., at energy
level 1, one green light will
be lit, at energy level 2, two
green lights will be lit, etc.).
5. Place the treatment
window on the desired
treatment area, ensuring
full contact with the skin
and press the trigger
button (marked as
to release a flash.
6. Following each flash, move
the device to the next spot.
After each flash, the device
will take 1-3 seconds to be
ready for the next flash.
The safety sensor will not
trigger a flash if:
• The device is not properly
applied to the skin. In this
case, the status indicator
will turn "momentarily"
orange.
• Your skin tone is too dark/
tanned. In this case, the
status indicator will turn
"momentarily" red.
7. After the treatment, turn off
the device by pressing the
ON/OFF button. Unplug the
unit after each treatment
session.
Standby Mode
When the unit is left inactive
for more than 3 minutes the
device will revert to STANDBY
mode. This is indicated by a
Blinking Green light. Press the
ON/OFF button to return to
treatment mode.
Stamp or Gliding Mode
)
There are two recommended
methods for treatment: Stamp
or Glide.
For stamp mode
place the device on the
skin, press and release a
flash. This treatment is most
13