Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Operation and maintenance
A. Installation
NOTE
• Install the Clean Station in a place where
the floor and wall are level.
• If the power cord is too long for the
installation environment, coil the power
cord around the cable management post,
then put it in the fixing groove at the rear
of the Clean Station.
• If you reinstall the Clean Station to a new
position of 45 degrees or 1 m or more from
the previous installed place, recreate the
map using the SmartThings App. (If you use
the existing map, some places may not be
cleaned.)
B. Using the Jet Bot
B-1 Charging the Jet Bot
Charging
• Remove the yellow gasket attached to the
power switch at the side of the Jet Bot and
press the power switch to turn the Jet Bot
on.
• Place the Jet Bot on the Clean Station
manually to start charging.
- When the Jet Bot starts charging, the
Status Indicator of the Clean Station turns
white and after 1 minute, the Status
Indicator turns off automatically.
• Check the charging status.
- When charging starts, the Status Indicator
of the Jet Bot turns on (red, orange, or
yellow depending on charging progress),
it rises gradually, and changes to green
when the charging is complete.
Docking (Recharging)
• You can return the Jet Bot to the Clean
Station while cleaning to recharge.
- Press the [
] on the Jet Bot or use the
SmartThings App to select the recharging
function.
B-2 Starting cleaning
• Press the [
] on the Jet Bot to start
cleaning in Auto Clean.
• Press the [
] on the Jet Bot to stop
operation while cleaning.
- When pressing the [
returns to the Clean Station and starts
charging.
C. Cleaning the Jet Bot
Before maintenance work, you should turn off
the power switch at the side of the Jet Bot.
C-1 Emptying and cleaning the Dustbin
• Remove the dust on the filter and Dustbin,
clean them with water, and dry completely
in the shade.
C-2 Cleaning the brush
C-3 Cleaning the Driving Wheel
C-4 Cleaning the Sensor Window
• Wipe the Sensor Window with a soft cloth.
C-5 Cleaning the Fine dust Filter
D. Cleaning the Clean Station
Before cleaning the Clean Station, unplug the
power cord from the electrical outlet.
D-1 Replacing the Dust Bag
D-2 Cleaning the Fine dust Filter
• Do not clean the Fine dust Filter with water.
NOTE
• To maintain the best performance of the
Fine dust Filter, replace the filter at least
once a year.
• For detailed methods of use
and cleaning, refer to the QR
code.
], the Jet Bot
English
9
Werbung
Inhaltsverzeichnis
Fehlerbehebung
