Troubleshooting - Zeegma Paar Bedienungsanleitung

3.
Pour cold water into the water tank with the use of a mug
and lock the plug (fig. 4). NOTE! To prevent scaling inside the
EN
device, it is advisable to use a distilled or demineralized water.
4.
Fix the desired tip.
5. Connect the device to the source of power. The LED light will
flash and then start glowing constantly to inform the user that
the device is ready for operation.
6. Press the steam release key (fig. 7).
7.
Use the steam adjustment key (4, fig. A) to select the desired
amount of steam to be generated (fig. 8).
Accessories
NOTE! Accessories can be used only when the device serves as
a hand steam wash.
NOTE! Check the condition of the seal on the extension lead or
turbo nozzle before every use. Do not use the device if the seal is
missing or damaged.
1. Minor accessories must be attached to the turbo nozzle or
nozzle with a flexible extension lead. Make sure the accessories
have been locked in a suitable position.
2. The turbo nozzle can be used to clean very dirty surfaces, e.g.
shower cubicles, cookers, etc.
3.
The round nozzle with a brush can be used to remove the most
stubborn dirt, e.g. grease. The round nozzle with a soft hair
can be used to clean gentle surfaces, while the nozzle with
a metal hair – to clean hard surfaces, e.g. grouts.
4. The nozzle with a scraper can be used to clean an oven or
barbecue grill, for instance.

Troubleshooting

The device does not
start.
The device does not
generate steam.
Make sure the device is connected to
the source of power.
Check condition of the power cable.
Make sure there is water inside the
device.
Wait for a while after restarting the
device.