Zeegma Paar Bedienungsanleitung Seite 7

How to install the steam mop
1.
Insert the metal tube into the body of the device and make
sure it is locked in a suitable position (fig. 1).
2.
Insert the hand steam wash into the body of the device (fig. 2).
How to use the steam mop
NOTE! The device must be unplugged while you are pouring water
in and fixing the pad.
1.
Unscrew the water tank plug (fig. 3).
2. Pour cold water into the water tank with the use of the mug and
lock the plug (fig. 4). NOTE! To prevent scaling, it is advisable
to use distilled or demineralized water.
3. Put the microfiber pad on the device head.
How to clean hard surfaces
NOTE! Before you use the steam mop, please dust or sweep up
the dirty surface.
Information: do not use the steam mop if you have not installed
the microfiber pad.
Information: do not use the carpet pad if you intend to clean hard
surfaces.
1.
Connect the device to the source of power. The LED light will
flash and then start glowing constantly to inform the user that
the device is ready for operation.
2.
Lean the device backwards, keep the head with your foot (fig.
5). Water will start heating up.
3.
Start vacuuming, move the mop forward and backwards on
the surface in question.
4. To remove the carpet pad, press and hold the rear handle with
your foot and then lift the device (fig. 6).
5.
Use the steam adjustment key (4, fig. A) to select the desired
amount of steam (fig. 8).
How to use the hand steam wash
NOTE! Before you use the device in the hand steam wash function,
switch the device off and unplug. Make sure the device is not hot.
1. Press the hand steam wash release key (11, fig. A).
2.
Open the water tank by unscrewing the plug (fig. 3).
EN