Makita DTW181 Betriebsanleitung Seite 10

You can change the impact force in three steps: hard,
The function of
with pulling
rotation. When the bolt/nut gets enough loosened, the tool stops the impact and rotation.
For approximately
the impact
Impact force grade displayed
on panel
Hard
Soft
Reverse rotation auto stop
mode
NOTE: Reverse rotation
the tool
rotation auto stop mode, the impact force and speed are the same as Hard impact mode.
NOTE: When all
the tool
power. The
pulling the
tool does
NOTE: While pulling the switch trigger, the impact force grade cannot be changed.
soft, and Reverse rotation auto stop mode.
All manuals and user guides at all-guides.com
Reverse rotation
the trigger
one minute
force can
Maximum blows
3,600 min -1 (/min)
-1
2,000 min (/min)
3,600 min -1 (/min)
auto stop
rotates counterclockwise.
lamps on
is turned
impact force
switch trigger
not operate.
This allows a tightening suitable to the work.
Every time the
pressed, the
blows changes in three steps.
auto stop mode
fully in counterclockwise
after releasing the
be changed.
Purpose
Tightening when force and
speed are desired.
Tightening when
need
adjustment with
small
diameter
Loosening with auto stop
function.
mode is available
When rotating
the switch panel
off to save
grade can be
to the extent
10 ENGLISH
button is
number of
works only
tool
switch trigger,
Example of application
Assembling steel frames.
you Assembling furniture.
fine
bolt.
Disassembling bolts/nuts.
only when
clockwise in Reverse
go out,
the battery
checked by
that the