Accessories - Grabner Speed Eignerhandbuch

If the bow of your boat distinctly rises above
the water surface, then you ought to move
weight forward.
If the boat does not plane when at speed, you
need to move weight aft.
When using the boat on your own, we recom-
mend to move forward and counter balance
(luggage, fuel-tank...) to the bow, or to use a
tiller extension.
WARNING: poor trim may dangerously
destabilise the boat and may cause loss
of boat control!
Drain valve
The drain valve serves to drain the boat.
When travelling faster than the surrounding
water, spray water entering the boat is su-
cked off continuously.
When travelling in calm waters, close the
drain valve.
Check that the valve is always free of leaves,
grass etc.
IMpORTANT NOTICE for
Due to the narrow beam, the
not posses the same stability attributes as an
inflatable craft with a wider beam would. For
that reason takes due care not to steer ab-
ruptly and do not make any sudden turns or
unbalanced throttle movements whilst travel-
ling under engine. Furthermore, no weights
should be shifted in the boat when it is mo-
ving at speed. Such would adversely affect
the trim of the boat. Also avoid steering tight
curves when moving at high speed.
14
All manuals and user guides at all-guides.com
SPEED
:
does
SPEED

ACCESSORIES

– not contained in standard accessory supply
SPEED
►
Midship saet-board - accommodatead-
ditional person
►
Seatboard retaining-bracket - for low
seat position
►
Seatboard-padding - for soft seaing
►
Comfort-seat - with high aspect rear pa-
nel for best back support.
►
Seat-board pad with bag - for comfort
and on board tidiness
CAUTION: When the seat-board pad with
bag is fitted, paddling in kneeling position is
not possible.
► Oars and rowlocks - Rowlocks can be
attached individually on the eyelet lip.
Fitting
●
Remove the black knurled nuts and take
the pieces apart.
●
Feed the part with the bolts through the
eyelets into the desired position on the
eyelet lip.
●
Place the second part from the inside
onto the bolts and fasten the knurled nuts
firmly.
●
Push the oar with the rowlock into the
rowlock-socket.
NOTICE: The socket is supplied with a se-
curing bolt!
When not in use, the oars may be secured
to the eyelet lip by means of a line.
► Spraycover - protects against spray, rain
and cold
► Inboard bag - water tight bags with wel-
ded seams and semi water proof zip, fit
to the sea board eyelets or D-rings by
means of straps.
► Boat Trolley - for convenient transport
ashore
► Insert-floor - to stiffen and stabilizing
the boat
Fitting:
●
Place the insert-floor into the deflated
boat.