Led Indicators - nemaxx M1-Mini Original-Gebrauchsanleitung

LED INDICATORS

Red LED-Flashing once every 40 seconds: indicates that the smoke alarm device is
operating properly.
Red LED-Flashing:
when the test button is pressed, or when the smoke alarm device senses particles of
combustion and goes into alarm (constant pulsating sound), the red LED will flash once per
second.
The flashing LED and pulsating alarm will continue until the air is cleared or release test
button.
Red LED-Alarm silencer (Hush mode) indication:
The red LED will flash once every 8 seconds, indicating the smoke alarm device is in the
alarm silence (Hush) mode.
Low battery indication: An intermittent "chirp" with red LED flashes once every 40 seconds:
indicates that the smoke alarm device is low battery, you may press the test button for pause
alarm for 10 hours, but it will reset automatically after 10 hours.
Fault indication - The alarm chirp occurs every 40 seconds.
NOTE
When the units chirp once every 40 seconds, you can press the test button
temporarily for pausing this warning tone for 10 hours, it can still normally detect
smoke during this period, it only removes nuisance warning tone.
You can refer to „Trouble shooting" for a solution, if there are still failures, you MUST
replace it with a new alarm at once.
ALARM SILENCE (SILENCE MODE)
While the unit is alarming, push the test button, it will be paused for approx. 10 minutes.
The red LED will flash once every 8 seconds, it indicates the smoke alarm is running in
silence mode.
Smoke alarms are designed to minimize false alarms.
Smoke particles from cooking may set off the alarm if the alarm is located close to the
cooking area. Large quantities of smoke particles are generated from spills or when frying.
Using the fan on a cooker hood that vents to the outside (non-recirculating type) will also
help remove these smoke particles from the kitchen.
The alarm silence (test button) is extremely useful in a kitchen area or other areas prone to
false alarms. The silence feature is to be used only when you are certain that the alarm is a
false alarm, for example when smoke from cooking activates the alarm.
The smoke alarm will automatically reset after approximately 10 minutes, if after this
period, smoke particles are still present, the alarm will sound again.
The alarm silencer (silence mode) can be used repeatedly until the air has been cleared of
the condition causing the alarm.
EN
5
Version: 5.0
20.01.2017