Operating The Vehicle; Setting The Gear Mesh; Charging The Battery - FMS 1:18 Toyota FJ Cruiser Bedienungsanleitung

EN
Throttle stick position
Neutral point

Operating the vehicle

Step 1: turn on the transmitter, the headlamp of the transmitter will flash and enter the frequency matching mode.
Step 2: turn on the receiver switch, the headlight will flash and enter the frequency matching mode.
Step 3: when the transmitter and receiver are successful in frequency up, the front lights of the transmitter will be
on for a long time, and the front lights of the vehicle will be off.

Setting the Gear Mesh

The gear mesh is the clearance between the pinion and spur gears in your
vehicle. If the motor or gearing components are replaced,check that the
gears are not meshing too tightly as this may cause premature wear.

Charging the Battery

1.Connect the charger to a USB port then connect the battery to the charger.
2.When charging,the Green LED is flash, when charged, the Green LED is stable.
3.Do not let the battery charge unattended!
4. If the battery or charger is hot,disconnect the battery and charger immediately as this may be caused by an internal
short-circuit.
Top point of forward direction
2. Connect the battery to the charger.
Top point of backward direction
1. Connect the charger's USB port to a power source.
6