Disclaimer And Warning - DJI ACTION 2 Produktinformationen

EN

Disclaimer and Warning

Congratulations on purchasing your new DJI OSMO
document affects your safety and your legal rights and responsibilities. Read this entire
document carefully to ensure proper configuration before use. Failure to read and follow
instructions and warnings in this document may result in serious injury to yourself or
others, damage to your DJI OSMO product, or damage to other objects in the vicinity. This
document and all other collateral documents are subject to change at the sole discretion of
DJI OSMO. This content is subject to change without prior notice. For up to date product
information, visit http://www.dji.com and click on the product page for this product.
By using this product, you hereby signify that you have read this disclaimer and warning
carefully and that you understand and agree to abide by the terms and conditions herein. You
agree that you are solely responsible for your own conduct while using this product and for
any consequences thereof. You agree to use this product only for purposes that are proper
and in accordance with all applicable laws, rules, and regulations, and all terms, precautions,
practices, policies, and guidelines DJI OSMO has made and may make available.
DJI OSMO accepts no liability for damage, injury, or any legal responsibility incurred directly
or indirectly from the use of this product. The user shall observe safe and lawful practices
including, but not limited to, those set forth in this document. Notwithstanding the above,
your statutory rights under applicable national legislation are not affected by this disclaimer.
OSMO is a trademark of SZ DJI OSMO TECHNOLOGY CO., LTD. (abbreviated as "DJI
OSMO") and its affiliated companies. Names of products, brands, etc., appearing in this
document are trademarks or registered trademarks of their respective owner companies.
Introduction
The DJI Action TM
at depths of up to 60 m. When using the waterproof case, make sure the inside of the
waterproof case is dry and clean, properly locked, and that the waterproof rubber ring is
secure. Insert anti-fog inserts to prevent fogging. The button on the waterproof case can
trigger the power/record button of DJI Action 2.
Installation is shown in the figure. The DJI Action 2 Camera Unit and the DJI Action 2
Front Touchscreen Module are not included.
Make sure the anti-fog insert works properly. Replace the anti-fog insert regularly.
Clean the waterproof case after using. Make sure the waterproof case is clean at
all times.
CHS
免责声明和警告
感谢您购买大疆灵眸
法权益与责任。使用本产品之前，请仔细阅读本文以确保已对产品进行正确的设置。不遵
循和不按照本文的说明与警告来操作可能会给您和周围的人带来伤害，损坏本产品或其它
1
2 Waterproof Case can be used to make the DJI Action 2 waterproof
（DJI OSMO
TM
TM
) 产品。本文所提及的内容关系到您的安全以及合
TM
product. The information in this