Changing The User Pin In Admin Mode; Deleting The User Pin In Admin Mode - iStorage DISKASHUR M2 Benutzerhandbuch

11. Changing the User PIN in Admin Mode

Important: Changing the User PIN must comply with the 'User PIN Policy' if one has been configured as described in
section 7, which imposes a minimum PIN length and whether a 'Special Character' has been used. The Administrator
can refer to section 9 to check the user PIN restrictions.
To change an existing User PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
KEY ( ) + 3 buttons
2. Enter New User PIN and press KEY ( ) button once
3. Re-enter the New User PIN and press KEY ( )
button once
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid

12. Deleting the User PIN in Admin Mode

To delete an existing User PIN, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
BLUE LED) proceed with the following steps.
1. In Admin mode press and hold down both
SHIFT ( ) + 3 buttons
2. Press and hold down both
SHIFT ( ) + 3 buttons again
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
BLUE LED), press and hold down the SHIFT ( ) button for a second - the
RED LED.
www.istorage-uk.com
Solid BLUE LED will change to blinking
solid BLUE LEDs
Blinking GREEN and solid BLUE
a single GREEN LED blink and then back to blinking
GREEN and solid BLUE LEDs
Blinking GREEN and solid BLUE
rapidly blinking GREEN LED and finally to a solid
BLUE LED indicating the User PIN has been
successfully changed
Solid BLUE LED will change to a blinking
Blinking RED LED will change to a solid
and then to a solid BLUE LED indicating the User
PIN has been successfully deleted
GREEN and
LEDs will switch to
LEDs change to a
RED LED
RED LED
#13