How To Perform A Complete Reset; How To Configure Diskashur M As Bootable - iStorage DISKASHUR M2 Benutzerhandbuch

35. How to perform a complete reset

To perform a complete reset, the diskAshur M
Admin/User PINs, the encryption key and all data will be deleted and lost forever and the drive will need to be formatted before it can be
reused. To reset the diskAshur M
1. In standby state (solid RED
hold down "0" button
2. Press and hold down both 2 + 7 buttons
Important:
to Configure an Admin PIN after a Brute Force attack or
formatted before any new data can be added to the drive.
36. How to configure diskAshur M
Note:
When the drive is set as bootable, ejecting the drive from Operating System will not force the LED to
turn RED. The drive stays solid
diskAshur M2 is configured as non-bootable.
The diskAshur M is equipped with a bootable feature to accommodate power cycling during a host boot process. When booting from
2
the diskAshur M , you are running your computer with the operating system that is installed on the diskAshur M
2
To set the drive as bootable, first enter the "Admin Mode" as described in section 5. Once the drive is in Admin Mode (solid
LED) proceed with the following steps.
1. In Admin mode, press and hold down both
KEY ( ) + 8 buttons
2. Press "0" followed by a "1" (01)
3. Press the SHIFT ( ) button once
Note: To immediately exit Admin Mode (solid
solid BLUE LED switches to a solid
#26
must be in standby state (solid
2
proceed with the following steps.
2
LED) , press and
After a complete reset a new Admin PIN must be configured, refer to Section 25 on page 20 on
GREEN and needs to be unplugged for next time use. The default setting of the
BLUE
RED LED.
RED LED). Once the drive is reset then all
Solid
GREEN
RED, GREEN
become solid for a second and then to a solid
LED indicating the drive has been reset
Reset', the diskAshur M
as Bootable
2
Solid
BLUE
GREEN
Blinking
solid
indicating the drive has been successfully
configured as bootable
LED), press and hold down the SHIFT ( ) button for a second - the
www.istorage-uk.com
RED LED will change to all LEDs, RED,
and BLUE blinking alternately on and off
and BLUE alternating LEDs will
will also need to be
2
.
2
BLUE LED will change to blinking
LEDs
and BLUE LEDs will continue to blink
GREEN and BLUE LEDs will change to a
GREEN LED and finally to a solid
RED
'How
BLUE
GREEN and
BLUE LED