Husqvarna LC 142i Bedienungsanweisung Seite 13

6. Remove the battery from the battery charger.
Battery charging status
A Husqvarna Li-ion battery can be charged or used at
all charging levels. The battery is not damaged. A fully
charged battery will not decrease its charge when the
battery is left in the charger.
LED display
LED 1 flashes
LED 1 is lit, LED 2 flashes 25%-50%
LED 1, LED 2 are lit, LED
3 flashes
LED 1, LED 2, LED 3 are
lit, LED 4 flashes
LED 1, LED 2, LED 3,
LED 4 are lit
To start the product
1. Open the battery lid.
2. Put a charged battery in the battery holder.
3. Turn the safety key to 1.
4. Stay behind the product.
5. Loosen the start inhibitor.
1692 - 003 - 15.12.2021
Charging status
0%-25%
50%-75%
75%-100%
Fully charged
6. Push the motor brake handle in the direction of the
handlebar.
To use the drive on the wheels (LC
142iS)
• Push the drive bail in the direction of the handlebar.
• Release the drive bail to disengage the drive, for
example when you go near an obstacle.
• Before you pull the product rearward, disengage the
drive and push the product forward approximately 10
cm.
To use the SavE
The product has a battery saving function (SavE
gives longer operation time.
™
• Push the SavE button to position 1 to start the
function.
™
• Push the SavE button to position 0 to stop the
function.
Note:
™
The SavE function stops automatically if the
ground conditions make it necessary to have a higher
™
output. The SavE function starts automatically again
when the ground conditions let it.
™
function
™
) that
13