WolfVision EYE-12 Bedienungsanleitung Seite 2

Precautions
Dangerous voltage inside
Please follow these precautions:
USE THIS MACHINE ONLY WITH THE CORRECT VOLTAGE AS SHOWN ON THE TYPE LABEL!
DO NOT EXPOSE THE UNIT TO EXTREME HEAT OR MOISTURE!
PROTECT THE UNIT FROM EXCESSIVE SHOCKS!
Make sure that sufficient air circulation for cooling the unit is possible!
If there is any abnormality (abnormal noise, smell, smoke etc.) disconnect the unit from mains
immediately and contact your WolfVision dealer!
Do not use a damaged power cord / power supply.
This may cause short circuits or electrical shocks!
To prevent danger, do not modify the unit or operate it without the cover panel firmly in place!
Do not expose the unit to water, metallic objects or any flammable material.
Never touch the power supply or power cord with wet fingers.
Avoid installing the unit in environments where there is radiation.
Avoid installing the unit in locations exposed to strong magnetic fields or electrical currents. This
could cause monitor image distortion or damage to the CCD camera.
If the unit is not used for a long time, disconnect it from mains!
The power source equipment
or UL 1950. And it shall comply with all applicable local and national codes related to safety.
The Power over Ethernet power equipment (PoE PSE) shall be classified as Limited Power Source
(LPS) in accordance with IEC 60950-1:2001.
Precautions for laser pointer
Laser light - Do not stare into beam!
Information for laser pointer
FDA accession number: 9912688-00
This device complies with 21 CFR 1040.10 and 1040.1 1
Technical data:
λ= 635 - 680nm
P< 1mW
Θ 2mrad
WARNING!
Risk of electric shock
has to be approved by CSA or UL in accordance to CSA 22.2-60950
This label will be found
on the underneath of
the remote control.
1
ENGLISH
The laser beam exits the
remote control through
the smaller (left) opening
on the front.
.