Operation; Before Switching On; Starting The Massage - Beurer MC4000 Gebrauchsanleitung

6.

Operation

Warning!
• Before using the device for the first time, read the
safety notes in the Safety section.
Safety, pages 11 to 12
w
Caution!
• If you experience irritations of any kind, stop
treatment immediately.

Before switching on

• Wear comfortable clothes during the massage.
• Remove all objects from your trouser pockets (e.g.
keys, pocket knife, mobile phone).
• Assume a comfortable, relaxed position.
• Always sit in the middle of the seat so that your
spine is positioned precisely between the massage
rollers.

Starting the massage

> Start the massage using the
After it is switched on, the massage chair goes into
a semi-flat position and begins with the refresh
massage programme.
The air pressure massage is switched on at low
intensity.
Flat position/upright position
The sitting position can be adjusted
even when the massage function is
switched off.
Switching off the massage chair
After the massage programme is finished, the chair
automatically enters standby mode.
Caution!
Do not use the device for longer than 20 minutes at a
time otherwise the device could overheat. Allow the
device to cool for at least 20 minutes before using it
again.
on/off button.
Putting the massage chair in the flat position
• Press the
position.
This lowers the back rest and raises the leg rest at the same time.
> Press the
reaches the desired position.
The motion stops; back rest and leg rest stay in this position.
Putting the massage chair in the upright position
> Press the
position.
This raises the back rest and lowers the leg rest at the same time.
17
Important!
• Never remove the pillow or back cushion during the
massage.
• The massage should feel pleasant and relaxing
at all times. If the massage is painful or
uncomfortable, stop the massage or change your
sitting position.
• If the device has not been used for a longer period
of time, check that the device is functioning
correctly before use.
• To change to a different massage programme,
press the relax or therapy button.
• Press the air button to alter the intensity of the
air pressure for the seat- and calf-area massage or
switch it off completely.
down button to put the massage chair into the flat
down button once again as soon as the chair
up button to put the massage chair into a higher flat
During the massage, you can switch off the device at
any time using the on/off button.
The massage chair returns to the start position. The
operating display flashes.
> Switch off the massage chair using the main switch
beneath the back rest.
> Pull the mains plug out of the socket.