Operation - Fujitsu GENERAL ASH9QM Bedienungsanleitung

OPERATION

To Select Mode Operation
1 Press the START/STOP button (Fig.6 N).
The indoor unit's OPERATION indicator lamp (red) (Fig. 3 6) will light.
The air conditioner will start operating.
2 Press the MASTER CONTROL button (Fig.6 I) to se-
lect the desired mode.
Each time the button is pressed, the mode will change in the following
order:
s
AUTO
t
HEAT
About three seconds later, the entire display will reappear.
To Set the Thermostat
Press the SET TEMP. buttons (Fig. 6 J).
button: Press to raise the thermostat setting.
button: Press to lower the thermostat setting.
GThermostat setting range:
AUTO .................................. Standard temperature setting ± 2 °C
Heating ............................... 16 to 30 °C
Cooling/Dry ........................ 18 to 30 °C
The thermostat cannot be used to set room temperature during the FAN mode
(the temperature will not appear on the remote control unit's display).
About three seconds later, the entire display will reappear.
The thermostat setting should be considered a standard value, and may differ
somewhat from the actual room temperature.
To Set the Fan Speed
Press the FAN CONTROL button (Fig. 6 M).
Each time the button is pressed, the fan speed changes in the following order:
s s
AUTO HIGH
About three seconds later, the entire display will reappear.
When set to AUTO:
Heating : Fan operates so as to optimally circulate warmed air.
However, the fan will operate at very low speed when the temperature
of the air issued from the indoor unit is low.
Cooling : As the room temperature approaches that of the thermostat setting,
the fan speed becomes slower.
Fan : The fan will operate at the optimum speed in accordance with the
room temperature in the vicinity of the indoor unit.
When set to QUIET:
SUPER QUIET operation begins. The indoor unit's airflow will be reduced for qui-
eter operation.
G SUPER QUIET operation cannot be used during Dry mode. (The same is true
when dry mode is selected during AUTO mode operation.)
G During Super Quiet operation, Cooling performance will be reduced somewhat.
To Stop Operation
Press the START/STOP button.
The OPERATION indicator lamp (red) (Fig. 3 6) will go out.
s s
COOL DRY
t
FAN
s s
MED LOW s QUIET
Example: When set to COOL
Example: When set to 26 °C
Example: When set to AUTO
En-6