AEG IWQ 60 Bedienung Und Installation Seite 10

product and the pull cord switch are out of the reach of
children. If it is installed in a bathroom, it should be positio-
ned so that it cannot be touched by anyone who is in the
bath or in the shower.
● The safety zones defined by your local electrical installa-
tion Standards or the Safety regulations applicable in your
country are to be exactly observed. In any case never in-
stall the heater inside the patterned areas called ZONE 0,
1 and 2 shown in picture 3.
● After use we recommend to leave the product cool down
for at least 10 – 15 minutes before touching it
● Before the appliance is started up for the 1st time check
that all the plastic pieces used in the packaging or to pro-
tect the tube element have been removed.
● During commissioning of the appliance, the heating ele-
ments may briefly emit low levels of smoke and odour.
This is non-hazardous. The smoke and odour will disperse
within a few seconds.
Make sure that the room is adequately ventilated (with a
partially open window, for example).
● The appliance is unsuitable for continuous operation.
Temporarily switch off the appliance after max. 10 hours of
runtime and allow it to cool down.
2) Installation
We recommend to switch off the mains electricity supply before proceeding
with the following steps.
We recommend to switch off the mains electricity supply before proceeding
with the following steps.
• Remove the front cover of the control unit by unscrewing the cross head
screw on the front (picture 4)
• Prepare the 3 holes (diam. 5mm) in the wall respecting the distances shown
in picture 5. You can also use the control unit or the detachable frame from the
box as a reference. See picture 6.
• Insert the 3 rawplugs you have found in the box.
• Fasten the appliance to the wall using the supplied screws (picture 9);
• This infrared quartz heater can be installed with the control unit on the right (
as supplied) or on the left ( pictures 7 and 8). The product is pre-assembled to
be installed with the control unit on the right. If you want to turn it to the left you
have to:
• Keep the product horizontally (do not pivot it!);
• Remove the screw from the indicated position "1" (see pictures 7a and 7b);
10