Beurer MG 70 Gebrauchsanleitung Seite 7

tachment that you prefer. With M+H intrared heat treatment, any massage attachments will
prevent the heat supply of the infrared source. You should therefore only operate the device
on ‚M' if a massage attachment is fitted.
Make sure that the device is switched off before inserting the power cable. Switch on the
device by setting the sliding switch to
‚M' (‚Massage only') or
‚M+H' (‚Massage with infrared heat').
Set the required massage speed using the control. Place the device on the part of the body
which you wish to massage. You can stand up, sit down or lie down and you can either mas-
sage yourself or massage somebody else. Massage intensity can be varied by exerting more
or less pressure on the massage device. Never massage a specific part of the body for longer
than 3 minutes without changing to another area of the body. After using for a maximum of 20
minutes, switch off the device again, disconnect the plug and let it cool down. Store the de-
vice in a dry place.
4. cleaning
To clean the unplugged device after it has cooled down, wipe with a slightly damp cloth. You
can use a mild cleaning agent. However, ensure that water never gets inside the device. Do
not use the device again until it is completely dry.
5. Disposal
Please dispose of the device in accordance with the directive 2002/96/EG – WEEE
(Waste Electrical and Electronic Equipment). If you have any queries, please refer to the
local authorities responsible for waste disposal.
7