Appliance Equipment; Installation - BOMANN DU 623.3 Bedienungsanleitung, Garantie

Appliance Equipment

Appliance overview
1 Control panel
2 Glass canopy,
foldable
Delivery scope
2x aluminum grease filter, 1x connecting piece with
non-return valves, 1x cover for extraction outlet,
incl. installation material and drilling template
This product contains a light source of energy effi-
ciency class G.

Installation

The cooker hood is only intended to be installed
over a hob with no more than four hob elements
There must be a safety distance between the hot-
plate of the cooking pot on the hob and the bottom
part of the cooker hood:
The distance must be between 60 – 75 cm. For gas
appliances, the distance must be at least 65 cm. If
the installation instructions for the gas cooker specify
a greater distance, this distance must be taken into
consideration.
Selecting the fume outlet
You can operate the cooker hood in two modes.
To do this, turn the lever located on the motor fan
unit in the corresponding position.
3 Aluminum grease
filter
4 Lighting
.
A: Extraction mode (outdoor air ventilation)
B: Recirculation mode (Indoor air ventilation)
Set the connection piece for the extraction mode A
and the outlet cover for the recirculation mode B onto
the air outlet. Read the instructions that we give you
"Assembly"
in as well.
Extraction mode
WARNING:
 The extracted air may not be vented into a flue
which is used for the waste gas from appliances
which are powered by gas or other fuels.
 When venting the extracted air, comply with the
regulations of the relevant local authorities.
The hood has an upper air outlet to vent cooking
odors to the outside.
The extracted air is normally vented vertically.

The extracted air can vented through the wall
units and the loft floor to the roof ridge.
If there is a conduit under the wall units, the ex-

traction duct can be routed so that the extracted
air can be vented horizontally through the wall.
18