BOMANN DU 623.3 Bedienungsanleitung, Garantie Seite 19

Recirculation mode
If you do not have a direct extraction vent to the out-
side; the hood can also work in recirculation mode
(i.e. without an extraction vent to the outside; the
filtered air is released back into the room). In this
case, an activated carbon filter mat as described
"Installing the activated carbon filter mat for
under
recirculation mode"
, must be used.
The activated carbon filter mat is not supplied. You
can order the mat from your dealer or in our online
accessories shop, www.bomann-germany.de. To
order, use the reference number found under
nical Data"
.
Assembly
WARNING:
 When assembling or inserting the extraction filter
as well as the carbon filter, the appliance must not
be connected to the mains.
 Failure to use the mounting fixtures may lead to a
risk of electric shock.
CAUTION:
 Before mounting, check that the wall has enough
load capacity to bear the cooker hood.
 When drilling the holes in the wall always make
sure that no existing electrical cables or other ob-
jects are damaged.
 Make sure that the ventilation slots are clear of
obstacles and are not covered.
NOTE: Recommendations for preparation work
 When installing, ask another person to assist.
 Wear protective gloves to prevent injuries from
any sharp edges.
1
2
3
"Tech-
4
5
6
Mounting at the wall
Mounting below the wall unit
 The hood is mounted at the wall or below a suita-
ble wall unit. Determine the position of the extrac-
tor hood centrally above the hob in conformance
with the specified safety distances.
 Remove the aluminum grease filter.
 Select the fume outlet and set the lever to the
appropriate position, see
let".
Mounting at the wall
 Mark the necessary holes for the wall mounting by
using the supplied drill template and check them
with a spirit level!
 Drill two mounting holes Ø 8 mm into the wall and
insert the dowel pins (1). Then turn in the screws
(2) so far that they project approx. 4 mm out of the
wall.
 Suspend the hood and tighten the screws through
the housing. Check the secure fitting and horizon-
tally position.
Mounting below the wall unit
 Hold the hood to the specified cabinet position
and draw the drilling points from the inside of the
housing corresponding to the four screw holes.
Check them with a spirit level!
19
"Selecting the fume out-