Operation; Setup And Use; Using The Tyre Inflator With Pressure Gauge; Using The Accessories - Parkside PDSS C3 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

 Operation

Setup and use

 
NOTE: Always operate the product with com-
pressed air that is clean, oil-free and moisture-free.
Do not exceed the maximum working pressure of
8 bar at the device.
NOTE: To be able to control the air pressure,
the compressed air supply must be equipped
with a pressure regulator.
Connect the product to a suitable compressed
† 
air source by plugging the quick-connect plug
on the supply hose to the barbed fitting
the product. The plug locks into place
automatically.
Using the tyre inflator
 
with pressure gauge
1. Plug the valve connector
2. Press the trigger lever
compressed air.
3. Release the trigger lever
compressed air. Use the pressure gauge
check the pressure.
4. If the pressure is too high (too much air) in the
object you are filling: Press the vent valve
release some air.
5. Press the lever on the valve connector
and unplug the valve connector
valve.
6. Disconnect the device from the compressor
after completing work.

Using the accessories

 
Press the lever on the valve connector
† 
plug in accessory parts
9
attachment into the valve connector
292180 Druckluft-Einstiegs-Zubehoer-Set_content_LB6.indb 9
All manuals and user guides at all-guides.com

1. Screw an extension nozzle
2. Press the trigger lever
3. Release the trigger lever
4. Disconnect the device from the compressor
NOTE: Detach the hose from the compressor first,
before you remove the supply hose from the device.
This will prevent a situation where the supply hose
whips around uncontrollably.
4
on

Always disconnect the device from the compressed
air supply before cleaning it.
5
into the valve The device does not require special maintenance.
6
to start supplying
6
to stop supplying 
1
to
„
3
to
„
5
down
5
from the
„
5
and
10 13
to or the
5
.

Using the air blow gun


7
pneumatic air blow gun
6
compressed air.
6
compressed air.
after completing work.

Maintenance


DANGER OF INJURY!

Care and cleaning


Do not use sharp objects to clean the device.

Do not allow liquids to get inside the device –
this can cause damage to the device.
Clean the device regularly. The best time to do

so is straight after completing work.
Clean the device housing with a dry cloth.


Operation

8
onto the
.
to start supplying
to stop supplying
9
GB/IE/NI
27.11.17 13:50