Troubleshooting - Zipper ZI-RMM95 Bedienungsanleitung

In order to tighten the belt, please adjust it with
a bolt being positioned on the motor plate.
Storage
Store the machine dry. Disconnect the machine
from the power supply and the air compression
supply.
Release the tension of the hydraulic system be-
fore disconnecting it (16) from the compressed
air supply.
Disposal
Contact your local authorities for information
about best available disposal possibilities in your
area. Drain the oil from the lubricant container
(17) completely before disposing the machine.
Disaggregate the machine into its components
before disposing them.

8 TROUBLESHOOTING

Always disconnect the machine from the power
and compressed air supply!
Tyre disc turns in one direction only
Problem: commutator broken
solution: let commutator be replaced
Tyre disc does not rotate at all
Problem: defect belt
Solution: replace belt
Problem: belt not tensioned
Solution: tension the belt
Problem: commutator broken
solution: let commutator be replaced
Problem: motor defect
Lösung: let this possibity be checked by a certi-
fied electrician who should check the power sup-
ply, the cables and the motor to localize the error
exactly.
Tyre disc stalls during rotation
Problem: belt slips
Solution: clean + tension belt
Clamping jaws open/close too slowly
Problem: pressure air silencer in the machine
Solution: Through belt access door you gain ac-
cess to silencers as well, clean them!
Release pressure from hydraulic system before-
hand!
Jaws do not clamp rim sufficiently
All manuals and user guides at all-guides.com
Problem: insufficient compression rate supply
Solution: check compression air supply pressure
Problem: jaws defect
Solution: replace jaws
Problem: pressure air silencer in the machine
Solution: Through belt access door you gain ac-
cess to silencers as well, clean them!
Release pressure from hydraulic system before-
hand!
Problem: clamping cylinder defect
Solution: replace cylinders
9 GUARANTEE
Warranty claims based on your sales contract
with your HOLZMANN retailer, including your sta-
tutory rights, shall not be affected by this guar-
antee declaration. Zipper Maschinen grants 1
year of spare part guarantee, reduced to 6
months for tools in commercial use, valid from
the purchase date on the sales receipt.
The guarantee covers the replacement of de-
fect/deficient machine parts/components whose
defect/deficiancy can be verified adequately that
The guarantee covers the replacement of de-
fect/deficient machine parts/components whose
defect/deficiency can be verified adequately that
the deficiencies were caused by a material or
manufacturing fault. The Guarantee does not
cover: Wear and tear parts like belts, cutters
etc.., except to initial damage which has to be
claimed immediately after receipt and initial
check of the machine. Defects of the tool caused
by non-compliance with the operating instructi-
ons, improper assembly, improper use, impact of
foreign forces like stones, tree trunks etc ..., in-
sufficient servicing or maintenance.
Damages being the causal effect of performed
manipulations, changes, additions made to the
machine. Slight deviations from the specified
quality or slight appearance changes that do not
affect functionality or value of the tool.
18