Operation - Zipper Zi-Rmm95 Bedienungsanleitung

If you notice any damages or missing parts
please inform immediately your reseller you
bought the machine from.
Please understand that later reclamations from
transport damage or missing parts cannot be
accepted anymore.
5.3 Workplace requirements
Choose a suitable site for the operation. It must
fulfill the regulations for workplace safety appli-
cable in your country and must provide a suitable
electronic supply connection and pressure air
connection with 8-10bar.
The ground must be level and solid and capable
to bear the machines weight.
Take care to position the machine so that it has
at least 1m of free space around.
Do not operate the machine in working environ-
ments with elevated fire or explosion hazard.
Do not operate the machine outdoors or in damp
areas or under conditions with humidity over 70°.
Fix the machine through the 4 drills in the ma-
chine base to the underground!
5.4 Electric connection
A T T E N T I O N
Do not connect the machine to a non
–secured non grounded electronic
supply:
Severe injury and even death may
arise due to an electronic malfunc-
tion of the machine!
The connection of the machine to the electric
power supply and the following checks are to be
carried out by respectively certified electricians
only!
The electronic connection of the machine is des-
ignated for operation with a grounded power
socket!
The connector plug may not be altered or manip-
ulated!
A damaged cable has to be replaced immediate-
ly!
The supply net must be secured with at least
16A.
Check, whether the supply net voltage and fre-
quency complies with the machine motors re-
quirements!
All manuals and user guides at all-guides.com
5.5 Compressed air connection
Connect the machine to compressed air supply at
the compressed air connection (16). ATTENTION:
The ZI-RMM95 may be only operated with pres-
sure levels between 8-10 Bar.
5.6 Test run
Check the function of the foot pedals and of the
pressure air hose.
If you notice any malfunctions check all connec-
tions again.

6 OPERATION

In order to avoid damages, use the
provided mounting lever to initiate the
demounting and mounting of tyres.
The connecting area between tyre and
rimbed, where the bed-breaker separates
the tyre from the rim, should always be
lubricated with suitable lubricants to pre-
vent the rim from damage.
Check for eventual prescribed running
directions for tyre mounting of the tyre
wall.
Tyres and rims must match together re-
garding their technical dimensions.
Always check the tyre extensively for any
abnormalities like deformation, surface
damage, excessive or uneven wear etc.
before mounting it.
Always check whether tyre/rim requires
special mounting procedures. For this
inform yourself in documentations etc. oft
he respective manufacturer.
When inflating tyres, check tyre pressure
and tyre form frequently.
A T T E N T I O N
15